Powersports Factory

Pressure-activated petrol tap with M16 thread for GY6 scooters with metal tanks. Delivery also includes the small pre-filter pipe that sits in the ...

Naraku unrestricted CDI unit for horizontal Minarelli engines and some 2-stroke Chinese-built models. Not suitable for vehicles with a Ducati ignit...

Very low-cost intake manifold for derestricting the inlet port. This increases the size of the opening to 21mm. This is a must when using a larger ...

Malossi piston ring set for all 70cc Malossi sports cylinder for Minarelli and Morini AC + LC engines. Suitable for all 70cc Malossi pistons with 2...

Aftermarket carburettor for all 2-stroke scooters with 1E40QMB engines. Minarelli replica air-cooled. Comes with electric choke. Note: In rare case...

Gasket for vehicles not fitted with a round exhaust manifold gasket. This is a universal gasket for all flat exhaust manifolds. Solid design and a ...

Aluminium height adjuster set for rear shocks, from Naraku Performance. This height adjuster set gives scooters a more dynamic look by raising the ...

Complete steering bearing sets including bearing races, ball bearings and locknuts. Bearing set for 27mm fork bridge.

Gasket for vehicles not fitted with a round exhaust manifold gasket. This is a universal gasket for all flat exhaust manifolds. Solid design and a ...

Aluminium height adjuster set for rear shocks, from Naraku Performance. This height adjuster set gives scooters a more dynamic look by raising the ...

Naraku Sports Contra Spring V.2 +1000 rpm The current version of the Naraku counter pressure spring uses a modified alloy spring providing better r...

39mm clutch nut M28x1 (central nut under the clutch bell). Suitable for Minarelli, Kymco, Peugeot, Honda engines and many more.

Cylinder studs including special nuts with M7 thread for securing the cylinder. Set of 4 with nuts. Length: 110mm, nuts are 13mm in length and have...

Replacement indicator glass for various CPI, Keeway, Kymco and Rieju scooters, geared mopeds and ATVs. The turn signal lens corresponds to the orig...

Rotor puller for removing the alternator flywheel. Our list is based on experience, but you are best to measure threads prior to ordering. Attentio...

High-quality, precision complete gasket set from Spanish gasket specialists Artein Gaskets. The materials are carefully matched to the specific dem...

M12x1.25mm nut for rotor and pulley on the crankshaft. Suitable for all special cranks with M12 thread for Piaggio and Minarelli engines. E.g.: Sta...

New style oil filler bolt for Minarelli - Red

Kickstarter wheel [carrier] for upright and horizontal Minarelli and Minarelli-based 2-stroke engines as found in CPI, Keeway, Mawi, Longija etc.

Replacement reed block with steel petals. Suitable for all horizontal Minarelli engines, CPI, Keeway, Generic, Mawi, Longija, Morini engines, April...