Beeline

This bush sits in the crankcase cover and carries the kickstarter shaft. It can quickly become worn and cause kickstarter issues and, in extreme ca...

Complete, pre-assembled clutch unit consisting of a rear converter torque driver, torque spring, clutch housing and clutch shoes. A defective clutc...

Throttle cable for 125/150cc 4-stroke Chinese-built scooters. The throttle cable has a length of 212cm and fits almost every 125cc and 150cc model....

Naraku racing CDI for all CPI, Keeway, Longjia, Generic and Minarelli-based Chinese-built engines with a double connector. Simply swap for the orig...

NARAKU replacement piston set for 47mm cylinders. The piston has a CNC-machined oil grooves for enhanced lubrication at the piston skirt. The pisto...

Plastic fan wheel air cooling for CPI, Keeway, Generic, Mawi, Longija and other Chinese-built 2-stroke engines.

Little end bearings for Minarelli/Morini engines with 10mm gudgeon pins.

Air cut-off valve. This valve sits on the side of the carburettor and richens the mixture somewhat to avoid the engine running too lean.

Fan cover for 50cc GY6 139QMB/QMA engines. Includes a cover cap with hole for checking the ignition timing.

This isolator sits between the intake manifold and the cylinder head and can often cause poor revving and engine running when it no longer seals pr...

Wedge for positioning the alternator rotor on the crankshaft. lenght=13mm, wide=3mm, high=2,5mm

Kevlar belt from Polini. The most durable v-belt Polini offers has additional aramid fibre inlays that make this belt extremely resistant to tearin...

Polini Speed Clutch Bell. Better design than most original clutches and thus an ideal replacement for died down or misshapen originals. The improve...

Tuned engines generally develop their power higher in the rev range and the engine can lose performance at lower revs, meaning poor drive. To comba...

Naraku Sport-o racing clutch. Solid sports clutch that engages 1500-2000 rpm higher than standard, meaning better drive and traffic light starts. K...

Polini EVO II Speed Bell is lighter and more revvy than the previous model. The single-piece clutch bell is CNC-machined from a single block, unlik...

Naraku Sports Contra Spring V.2 2 Pack, +1000, +1500 rpm The current version of the Naraku counter pressure spring uses a modified alloy spring pro...

Set of 3 replacement sliding shoes for variator plates.

Original CDI unit for vehicles with a double connector in the CDI as factory-fitted. For assurance, please check the image for comparison. Also sui...

Alternator with cable connector/plug and Pick-up sensor. There are currently 2 different versions of this alternator. The difference is the insulat...

Complete steering bearing kit for some low-cost and Chinese-built scooters, incl. shells, ball races and locking nuts.