Jonway

As original kick-start shaft. A defective shaft is often the cause of sticking kick-starts, or noises when starting.

Plastic fan wheel for variators on GY6 50cc 139QMB/QMA engines. Belt damage is caused by too much heat in the drive area. For this reason, the fan ...

Complete speedo cable for GY6 125/150cc Chinese-built 4-stroke scooters. Length: 96cm. For added assurance, please check the original against the p...

This brake cylinder assembly is suitable for 125 and 150cc GY6 4-stroke Chinese-built scooters with rear brake discs. Supplied complete with hand l...

Naraku racing CDI for improved performance and speed. Simply swap for the original unit. You can get rid of your restricted factory-fitted CDI. Att...

O-ring for isolators and intake manifolds. The isolator sits between the carb and the intake manifold and often causes poor engine running as a res...

This bush sits in the crankcase cover and carries the kickstarter shaft. It can quickly become worn and cause kickstarter issues and, in extreme ca...

Complete, pre-assembled clutch unit consisting of a rear converter torque driver, torque spring, clutch housing and clutch shoes. A defective clutc...

Throttle cable for 125/150cc 4-stroke Chinese-built scooters. The throttle cable has a length of 212cm and fits almost every 125cc and 150cc model....

NARAKU replacement piston set for 47mm cylinders. The piston has a CNC-machined oil grooves for enhanced lubrication at the piston skirt. The pisto...

Complete tail light bulbs included. E-certificate. Suitable for all Chinese-built 4-stroke vehicles with vehicle design like the Rex RS450, Baotian...

Air cut-off valve. This valve sits on the side of the carburettor and richens the mixture somewhat to avoid the engine running too lean.

Fan cover for 50cc GY6 139QMB/QMA engines. Includes a cover cap with hole for checking the ignition timing.

This isolator sits between the intake manifold and the cylinder head and can often cause poor revving and engine running when it no longer seals pr...

Wedge for positioning the alternator rotor on the crankshaft. lenght=13mm, wide=3mm, high=2,5mm

Naraku Sport-o racing clutch. Solid sports clutch that engages 1500-2000 rpm higher than standard, meaning better drive and traffic light starts. K...

Polini EVO II Speed Bell is lighter and more revvy than the previous model. The single-piece clutch bell is CNC-machined from a single block, unlik...

Set of 3 replacement sliding shoes for variator plates.

Standard replacement drive belt suitable for vehicles with 10” wheels. Dimensions: 669-18-30

Original CDI unit for vehicles with a double connector in the CDI as factory-fitted. For assurance, please check the image for comparison. Also sui...

Alternator with cable connector/plug and Pick-up sensor. There are currently 2 different versions of this alternator. The difference is the insulat...

Complete steering bearing kit for some low-cost and Chinese-built scooters, incl. shells, ball races and locking nuts.