Kreidler

Complete transmission kit of Naraku components, all tuned to another. Since Chinese-built scooters are not kitted with top-end components out of th...

Very high-quality 3 in 1 tool for blocking and removing the variator and clutch bell, including integrated hex wrench to loosen the clutch retainer...

Seemingly the most robust clutch on the market in top quality with adjustable pre-tension. We offer a clutch spring set with various spring weights...

Replacement clutch bell from Malossi. Shaky drive from standstill could indicate an issue with the clutch bell. This will lead to damage in the clu...

The finest clutch bell you could use, with cooling vents for improved heat dispersion and reduced slip on the bell and plates.

Counter pressure spring by Polini for GY6 125/150cc, Kymco, Honda maxi scooters providing a 15% increase in pressure from the oriental spring and i...

The EVO clutch bell for various GY6, Kymco and Honda maxi scooters. Very lightweight and easy-spinning and CNC-machined from one solid block, unlik...

Naraku quality shaft seals for scooters with 125/150cc GY6 engines. Shaft seals are required on the rear of the convertor and seal in the convertor...

Complete set of quality crank oil seals from Naraku, for scooters with 125/150cc GY6 engines. Set contains all the important oil seals found in the...

Red anodized aluminium kick-starter with solid kicker head, suitable for various Honda and Kymco scooters. Great optical detail.

Aluminium kick-starter with solid kicker head, suitable for all Honda and Kymco scooters. Great optical detail.

Red anodized aluminium kick-starter with solid kicker head, suitable for all CPI and Keeway scooters. Great optical detail.

Arreche 23.5mm sealing ring for carbs with threaded flange.

Reinforced starter motor freewheel without starter sprocket, from Naraku. For original and tuned scooters with Minarelli-based, Chinese-built engin...

Naraku cylinder stud for horizontal Minarelli and Minarelli-based cylinder. Great as a replacement for broken or damaged studs. One individual stud...

Arreche 25mm sealing ring for carbs with threaded flange.

24mm intake manifold for maximum flow and performance. Ideally, you match the manifold to the size of the carb.

Competition 24mm carburettor kit from Arreche with manual choke for horizontal Minarelli engines, suitbale for 70cc high end racing engines. This s...

Replacement heat guard for standard original GY6 125/150cc engines.

Naraku double-layer air filter element for original air boxes. For standard or lightly-tuned engines. Check the product image to ensure you get the...

Cylinder base gasket for horizontal Minarelli and 1E40QMB engines. For air and water-cooled engines.

Air cut-off valve. This valve sits on the side of the carburettor and richens the mixture somewhat to avoid the engine running too lean. Needle is ...