Kreidler

Oil strainer bolt O-ring - 139QMB/QMA

Timing chain tensioner gasket for 139QMB/QMA.

Cylinder head gasket [50cc = 39mm] - GY6 50cc

This gasket sits in the valve cover in an identical metal plate and seals the crankcase breather. For valve covers with and without SLS.

Right-hand crankcase gasket - GY6 50cc

Gasket for the gearbox cover on GY6 50cc 4-stroke engines.

Naraku Racing variator for all 50cc 2-stroke Minarelli engines with upright and horizontal cylinders. The surfaces offer optimal ratio change. This...

The Tecnigas Next-R suitable for GY6 50cc 4-stroke and 4-stroke engines Kymco. This exhaust has a good energy yield with relatively low sound. In t...

Some scooters are sent from the factory with two rear shock absorbers. These models mostly use aluminium exhaust systems. These are generally mount...

Complete replacement engine for 125cc GY6 4-stroke 152QMI engines with a long block and rear disc brake. Long block models take an 743mm v-belt. Th...

Complete replacement engine for 125cc GY6 4-stroke 152QMI engines with a long block and rear disc brake. Long block models take an 835mm v-belt. Th...

SLS with hose for GY6 50cc exhaust systems with SLS. Often this part is necessary if the mounting bolts have rusted or locked, or the engine is run...

M10x1.25mm nut for front belt pulleys. For Minarelli engines or other models with the same dimensions. (Thread on the variator side of the crank).

Valve cover for GY6 125/150cc 4-stroke 152/157QMI engines WITH SLS system. The valve cover is ready to install and delivered as shown. Valve cover ...

Complete valve cover with connector for 50cc GY6 and Kymco 4-stroke engines. The valve cover is ready to install and supplied as shown. The valve c...

Complete cylinder head with pre-installed valves for all GY6 125cc 152QMI engines. Ready to install with SLS connector. Ready to install. Please no...

Replacement drive belt suitable for GY6 125/150cc engines with long blocks. Dimensions: 835-20-30

Replacement drive belt suitable for scooter with 12 or 13” wheels. Mostly used on 12” wheel vehicles with rear brake disc. On 13” models it i...

Rubber stops for the engine rockers. 2 items generally required when changing out.

Rubber centre stand stop for 125/150cc Chinese-built scooters. Suitable for most scooter types, but please check image against the original item.

Complete intake hose for the crankcase cover, with clamp. Suitable for crankcase covers on 125/150cc GY6 4-stroke engines.

Bolt and nut set for GY6 125/150cc engines. Set contains almost all bolts, oil draining plugs, nuts, cylinder studs etc. Ordering individual engine...

Outer v-belt pulley for GY6 125/150cc 4-stroke Chinese-built engines.

Naraku Torque Driver with 2 different linear guide slots. Most torque drivers have curved slots which is not ideal for performance gains but fine f...