Kymco

Gasket for vehicles not fitted with a round exhaust manifold gasket. This is a universal gasket for all flat exhaust manifolds. Solid design and a ...

This regulator is similar to the NARAKU ignition coil. The controller reaches a significantly higher output than the standard controller by ensurin...

Gasket for vehicles not fitted with a round exhaust manifold gasket. This is a universal gasket for all flat exhaust manifolds. Solid design and a ...

Aluminium height adjuster set for rear shocks, from Naraku Performance. This height adjuster set gives scooters a more dynamic look by raising the ...

Aluminium height adjuster set for rear shocks, from Naraku Performance. This height adjuster set gives scooters a more dynamic look by raising the ...

Exhaust manifold gasket with accurate fit to the factory installed exhaust system.

39mm clutch nut M28x1 (central nut under the clutch bell). Suitable for Minarelli, Kymco, Peugeot, Honda engines and many more.

Aluminium height adjuster set for rear shocks, from Naraku Performance. This height adjuster set gives scooters a more dynamic look by raising the ...

Cylinder studs including special nuts with M7 thread for securing the cylinder. Set of 4 with nuts. Length: 110mm, nuts are 13mm in length and have...

Twist Control: an absolute drive innovation from Naraku. Twist Control absorbs the torsion from the converter and even out the loss of power from t...

This Variator sleeve replaces the original factory fitted sleeve and collar. This lifts the restricted power. The scooter will be capable of approx...

Low-cost dropping resistor for the lighting system of various 50, 125 and 150cc GY6 4-stroke Kymco and Chinese-built scooters. (5 Watt / 5 Ohm &...

Naraku double-layer air filter element for original air boxes. For standard or lightly-tuned engines. Check the product image to ensure you get the...

Vacuum-operated fuel tap for various Kymco and SYM scooters.

Replacement speedo cable in original dimensions for scooters. Design and dual-side mounts match the original speedo cable. Length from end to end: ...

Set of 3 Naraku clutch springs for original clutches. 3 different strengths. Engagement point RPM alters in accordance with the value on the spring...

Carburettor flange for mounting push-on carburettor (e.g.: Dellorto, PHBG) for derestricted and restricted Kymco inlet manifolds. Dimensions: 20mm ...

Malossi carbon reed petals for improved responsiveness over steel variants. Should the petals break up, there is the added assurance that they will...

Naraku HD (Heavy Duty) crank main bearing set. Set contains left and right crank bearings in metal cage and relevant shaft seals. For horizontal-en...