Mirage 125

Innertube with 45° angled valve for smaller sized wheels. Our tip: Always replace innertubes when changing tyres.

Complete steering bearing set for 125/150cc 4-stroke Chinese-built scooters The manufacturer used a tapered roller bearing as the lower bearing and...

As original kick-start shaft. A defective shaft is often the cause of sticking kick-starts, or noises when starting.

Counter pressure spring by Polini for GY6 125/150cc, Kymco, Honda maxi scooters providing a 15% increase in pressure from the oriental spring and i...

The oil plug also measures the oil level and there is a measuring gauge on the dip stick, attached to the underside of the plug. Check item to be r...

Outer v-belt pulley for GY6 125/150cc 4-stroke Chinese-built engines.

Complete wheel-mounted speedo drive for 125/150cc 4-stroke Chinese-built scooters. As there are various types of drive fitted to these machines, pl...

Pressure-activated petrol tap for 50cc Chinese scooters with plastic tanks (e.g. New models of the Rex RS and Peugeot V-Clic) and most Chinese 4-st...

Standard CDI ignition unit as factory-fitted.

Starter relay or starter solenoid for 125/150cc GY6 4-stroke Chinese-built scooters. 2-pin connector.

Valve cover for cylinder heads without SLS. For all GY6 125/150cc 152/157QMI engines.

GY6 Racing CDI with no rev limiter. This CDI features a performance optimised ignition curve: ideal for later tuning mods, such as a big bore kit. ...

Low-cost dropping resistor for the lighting system of various 50, 125 and 150cc GY6 4-stroke Kymco and Chinese-built scooters. (5 Watt / 5 Ohm &...

Airsal 165cc [Sport] cylinder gasket set - GY6 152/157 QMI

Airsal 150cc [Sport] cylinder gasket set Racing - GY6 152/157 QMI

Repair kit for 24mm Naraku carburettors. Comes with adjustable needle, needle clip, main jet, pilot jet, float bowl gasket, idle jet, mix adjuster ...

Naraku racing CDI for improved performance and speed. Simply swap for the original unit. You can get rid of your restricted factory-fitted CDI. Att...

Naraku cylinder gasket set (58.5mm/160cc) 4-stroke

Original intake manifold for all GY6 125/150cc 152/157QMI engines. Delivery includes clamp and O-ring. 24mm opening.

Folding kickstarter lever for 125/150cc GY6 4-stroke Chinese-built engines.

This cylinder gasket set comprises all the necessary gaskets from the base gaskets up. Can be used on Naraku 4-stoke cylinders (NK600.10), but is a...