Geniune

Replacement oil pump drive gear for scooters with Minarelli-based 2-stroke Chinese-built engines and Minarelli 50cc 2-stroke AC/LC engines.

Naraku small end bearing [HD-Quality] - 10x14x13. Suitable for Minarelli and Morini engines with 10mm gudgeon pin.

These cylinder gasket sets contain all the necessary gaskets from the cylinder base upwards. They can be optionally used on Naraku 2-stroke cylinde...

Little end bearings for Minarelli/Morini engines with 10mm gudgeon pins.

Snap ring for Turbo Kit silencer with removable db killer.

gasket for the silencers at all Yasuni Scooter exhaust systems and geared moped exhaust systems. Suitable respect, not for Yasuni Carrera 30th

Small but great-looking coloured oil filler bolts in blue, red, orange or gold. 1x bolt of the required size supplied with relevant O-ring.

Low-cost, reinforced clutch spring set. The clutch engages approx. 1500-2000rpm later, allowing the engine to put more power down under acceleratio...

Brake light switch for drum brakes with cable. The switch sits on the brake fitting. To avoid errors when ordering, please check the product image....

Gear box cover gasket suitable for Minarelli engined scooter models.

Naraku cylinder stud for horizontal Minarelli and Minarelli-based cylinder. Great as a replacement for broken or damaged studs. One individual stud...

Arreche 25mm sealing ring for carbs with threaded flange.

Float bowl gasket for Keihin PWK carburettor.

39mm clutch nut M28x1 (central nut under the clutch bell). Suitable for Minarelli, Kymco, Peugeot, Honda engines and many more.

Airsal 50cc cylinder gasket set - Horizontal Minarelli AM6

New style oil filler bolt for Minarelli - Red

Gasket for vehicles not fitted with a round exhaust manifold gasket. This is a universal gasket for all flat exhaust manifolds. Solid design and a ...

Gasket for vehicles not fitted with a round exhaust manifold gasket. This is a universal gasket for all flat exhaust manifolds. Solid design and a ...

Accompanying kickstarter part. Should also be replaced when changing the cog.

Woodruff key with blunted edges for scooters with 50-180cc Piaggio 2-stroke engines. length=12mm, wide=3mm, high=5mm

24mm connector boot for Arreche carbs with clamping flange.

23mm connector boot for Arreche carbs with clamping flange.

Replacement indicator glass front and rear for various Derbi, Rieju, Yamaha and MBK scooters and geared mopeds. The turn signal lens corresponds to...

Locking spring for kick-starter carrier sprockets.

Self-locking nut M14x1.50mm for rear wheel shaft (central nut for rear wheel). Also for other Minarelli engines and other models with M14x1.50mm th...

Replacement star washer / shim from Naraku for securing the outer variator pulleys. Corresponds to the size and design on the original. For all hor...

Arreche 23.5mm sealing ring for carbs with threaded flange.

Cylinder head nut with M7 thread for all Minarelli and Minarelli-based engines, as well as other models with M7 threads on the cylinder stud bolts.