Piaggio

High Quality Racing full circle crankshaft from Top Racing. The specialist Portuguese crankshaft manufacturer is a symbol of high quality crankshaf...

Starter magnetic switch 12V, 80A as mounted on the original vehicle. Suitable for many MBK/Yamaha and Peugeot scooters. Defective relays are often ...

Complete alternator incl. stator, cables and pick-up. Ready to install. Great replacement for defective units.

Aluminium belt pulley with integrated air scoops. Very temperature stable component, smooth running and low-slip. Great for racing engines. Not for...

NARAKU sports variator for Piaggio engines up to 1998. When calibrated, this variator provides good acceleration at higher top speeds. The restrict...

Standard brake shoe set. 2x new springs supplied. Performance and design match the original. Shoe dimensions: 100x20mm For rear brake use on:

Very high quality Malossi crank. Typical Malossi high quality. Full cheek design for higher pre-compression, for max fill and moves the power band ...

Malossi Multivar variator for great drive and shifting, as well as increased top end. Original drive belt can be retained. Excellent Malossi qualit...

Malossi MHR carburettor kit contains Dellorto 19mm PHGB carb and all necessary mounting parts. Originally for regulated scooter trophy series with ...

Malossi 4 reed racing reed block. 0.3mm thick reeds give great power when used with the Malossi Big Valve blocks. Malossi offers 2 different thickn...

Naraku small end bearing [HD-Quality] - 12x17x13. Suitable for Piaggio, Gilera, Kymco, SYM.

High-quality replacement piston for 50cc original and 50cc Naraku cylinders for Piaggio AC and LC engines. Delivery as shown, including: piston rin...

Rotor puller for removing the alternator flywheel. No specific vehicle fitment. 26x1mm thread, but please measure thread prior to ordering.

Counter pressure spring by Polini [Evo-Slider] with a diameter of 50mm for Piaggio / Gilera scooters. The kit includes a eve slider plastic plates ...

Counter pressure spring by Polini [Evo-Slider] with a diameter of 50mm for Piaggio/Gilera scooters. The kit includes a eve slider plastic plates fo...

Counter pressure spring by Polini [Evo-Slider] with a diameter of 50mm for Piaggio / Gilera scooters. The kit includes a eve slider plastic plates ...

This piston ring set can be optionally used in Naraku 2-stroke cylinders, but is also suitable for original cylinders and standard cast iron cylind...

These cylinder gasket sets contain all the necessary gaskets from the cylinder base upwards. They can be optionally used on Naraku 2-stroke cylinde...

The Naraku Traffic system combines contemporary fresh lines with a pleasant engine note. This system integrates very well with new modern vehicles....

Malossi MHR intake manifold with short opening and straight connection. 22/28mm variant has a 22mm opening and the 28-30mm carb connection for MHR ...

Replacement speedo cable in original dimensions for scooters. Design and dual-side mounts match the original speedo cable. Length from end to end: ...