Simson

Scooter tyre innertube with 90° bent valve for easier pressure checks. Our Tip: Always replace the innertube when changing the tyre. Suitable for ...

Naraku High Performance clutch bell with patented R-Vent system for more fresh air over the clutch. Prevents wear and loss of friction. Lower opera...

Complete braking system with level and rear brake light switch for 125/150cc Chinese 4-stroke scooters with rear drum brakes. The fitting has a thr...

Malossi MHR intake manifold with short opening and straight connection. 22/28mm variant has a 22mm opening and the 28mm carb connection for MHR Tea...

Malossi 45° MHR Racing performance reed block with 2 single-piece reeds. 0.3mm for improved gas flow. Straight from the Malossi MHR racing departm...

Malossi Racing clutch spring set. Springs suitable for original clutches with 3 shoes. Set comprises 3 different spring strengths: black = light (t...

The big brother of the 50cc cylinder kit: the Airsal 70cc is a high torque sports cylinder with great low down power. Delivery includes: gasket set...

Malossi robust, high compression MHR Racing crank with 39.2mm standard stroke and 80mm standard rod length, designed for 10mm gudgeon pins. Safe up...

Naraku Sports Contra Spring V.2 +200rpm The current version of the Naraku counter pressure spring uses a modified alloy spring providing better res...

The bigger brother to the Naraku Racing Variator: the Naraku High Speed Racing V.2. The variator surface has been blast-hardened with glass beads, ...

M10x1 nut for clutch bells for all Minarelli and Minarelli-based engines.

The oil plug also measures the oil level and there is a measuring gauge on the dip stick, attached to the underside of the plug. Check item to be r...

Naraku HD (Heavy Duty) crank main bearing set. Set contains left and right crank bearings in metal cage and relevant shaft seals. Only bearings wit...

Buzzetti universal 3-point puller for alternator rotors. The 3 screws included in the delivery are simply screwed into the holes in the rotor. Then...

Starter motor for GY6 125/150cc, supplied with connector cable.

As original kick-start shaft. A defective shaft is often the cause of sticking kick-starts, or noises when starting.

Naraku racing CDI for improved performance and speed. Simply swap for the original unit. You can get rid of your restricted factory-fitted CDI. Att...

Complete, pre-assembled clutch unit consisting of a rear converter torque driver, torque spring, clutch housing and clutch shoes. A defective clutc...

Throttle cable for 125/150cc 4-stroke Chinese-built scooters. The throttle cable has a length of 212cm and fits almost every 125cc and 150cc model....

Naraku High Performance clutch bell with patented R-Vent system for more fresh air over the clutch. Prevents wear and loss of friction. Lower opera...

Little end bearings for Minarelli/Morini engines with 10mm gudgeon pins.

Polini Speed Clutch Bell. Better design than most original clutches and thus an ideal replacement for died down or misshapen originals. The improve...

Tuned engines generally develop their power higher in the rev range and the engine can lose performance at lower revs, meaning poor drive. To comba...