SYM (Sanyang)

Dowel pin set for 50cc GY6 engines Delivery contains: 6x dowel pins for M7 (cylinder, cylinder head) 6x dowel pins for M6 (engine cases, crankcase ...

Low-cost, standard brake shoes. Supplied with a set of new shoe springs. Size: 110x25mm Generally for rear brake use, but can be used for front on ...

Rubber bushes for engines mounts on GY6 139QMB/QMA engines.

Well priced 3 shoe replacement clutch in OEM-quality.

Standard Bosch spark plug with silver electrodes. This spark plug matches the heat value and construction of the original.

OEM-quality replacement carb with e-choke for various Honda, Kymco and SYM scooters. Main Jet: 70 Distance Between Mounting Holes: 35mm Air Filter ...

Complete steering bearing set with upper and lower bearing shells and bearings.

Air filter for original air box.

Scooter tyre innertube with 90° bent valve for easier pressure checks. Our Tip: Always replace the innertube when changing the tyre. Suitable for ...

Malossi strengthened counterpressure springs for rear Malossi convertors, Peugeot Type. Counterpressure springs place the drive belt under tension,...

Naraku Sports Contra Spring V.2 +2000RPM The current version of the Naraku counter pressure spring uses a modified alloy spring providing better re...

SLS Exhaust system gasket - 130QMB/A

SLS [secondary air system] gasket - 139QMB/A

Cylinder base gasket - GY6 50cc

Crankcase cover gasket [10”-669mm] - GY6 50cc

The oil plug also measures the oil level and there is a measuring gauge on the dip stick, attached to the underside of the plug. Check item to be r...

Naraku High Performance clutch bell with patented R-Vent system for more fresh air over the clutch. Prevents wear and loss of friction. Lower opera...

Starter motor for GY6 125/150cc, supplied with connector cable.

As original kick-start shaft. A defective shaft is often the cause of sticking kick-starts, or noises when starting.

Plastic fan wheel for variators on GY6 50cc 139QMB/QMA engines. Belt damage is caused by too much heat in the drive area. For this reason, the fan ...

Naraku racing CDI for improved performance and speed. Simply swap for the original unit. You can get rid of your restricted factory-fitted CDI. Att...

O-ring for isolators and intake manifolds. The isolator sits between the carb and the intake manifold and often causes poor engine running as a res...

Cost-effective replacement belt for everyday use. Good flex and outstanding grip and can easily be used in lightly tuned engines. Dimensions: 738x1...

Complete, pre-assembled clutch unit consisting of a rear converter torque driver, torque spring, clutch housing and clutch shoes. A defective clutc...