Vanguard 125

180cc Big Bore Kit for GY6 based 125/150cc + engines. The bore is 63 mm, meaning the cases must be worked to accept the cylinder. This requires pre...

Seemingly the most robust clutch on the market in top quality with adjustable pre-tension. We offer a clutch spring set with various spring weights...

Replacement clutch bell from Malossi. Shaky drive from standstill could indicate an issue with the clutch bell. This will lead to damage in the clu...

The finest clutch bell you could use, with cooling vents for improved heat dispersion and reduced slip on the bell and plates.

Counter pressure spring by Polini for GY6 125/150cc, Kymco, Honda maxi scooters providing a 15% increase in pressure from the oriental spring and i...

The EVO clutch bell for various GY6, Kymco and Honda maxi scooters. Very lightweight and easy-spinning and CNC-machined from one solid block, unlik...

Naraku quality shaft seals for scooters with 125/150cc GY6 engines. Shaft seals are required on the rear of the convertor and seal in the convertor...

Complete set of quality crank oil seals from Naraku, for scooters with 125/150cc GY6 engines. Set contains all the important oil seals found in the...

Engine mount for 125-150cc GY6 engines. Please compare with product image.

3 Set of sliders for the Naraku Maxi Speed variator for scooters with 125cc GY6 and Kymco AC engines.

Universal handlebar grip for scooters, motorcycles and quads/ATVs with 22mm diameter handlebars. outer length: 120mm inner length: 115mm

Rotor/magnet wheel for alternators. Alternators are currently available with 6 or 8 coils. Please check your original item to check which one you r...

The rectifier/controller converts the alternating voltage from the alternator into the DC for the on board computer. This keeps the battery charged...

15mm gudgeon pin circlips from Naraku. Ensure the clip groove is clean and will allow the circlip to seat properly. When installing, we recommend o...

Variator back plate for GY6 125/150cc 4-stroke Chinese-built engines. This component corresponds to 100% of the original. Only for 15 mm tail shaft!

Counterpressure spring mounting tool for convertor units 125-155mm outer diameter.

Malossi Racing clutch spring set. Springs suitable for various Maxi scooters with original 3 shoe clutches from 125-200cc. Set comprises 3 differen...

Fan Wheel for air cooling. This item sits on the alternator rotor and is attached with 4 screws.

Complete piston kit including rings, gudgeon pin and gudgeon pin circlips for original or Naraku aftermarket cylinders. Of course, the cylinder has...

Complete cylinder kit with all gaskets and parts for fitting. This 125cc Naraku cylinder delivers engine performance corresponding to the original....

This cylinder gasket set comprises all the necessary gaskets from the base gaskets up. Can be used on Naraku 4-stoke cylinders (NK600.10), but is a...

Dowel pin set for 125/150cc GY6 engines. Delivery contains: 6x dowel pins for M8 and 8x dowel pins for M6.

Naraku clutch spring set for 125/150cc original and Naraku sports clutches for GY6, Kymco, Honda, Malaguti, Keeway Maxi scooters.+1500 rpm +2000rpm...

Current Naraku counterpressure springs with different alloying of the spring steel. A necessary addition where engines have been tuned. RPM increas...