Vento

Rotor/magnet wheel for alternators. Alternators are currently available with 6 or 8 coils. Please check your original item to check which one you r...

Complete engine gasket set for 125/150cc GY6 engines (152QMI). Contains all relevant gaskets. Cheaper than individual purchasing. Does not include ...

This intermediate transmission shaft is supplied pre-pressed. Same number of teeth as the original 13/52 teeth.

Gearbox input shaft. This is where the clutch is mounted. 13 teeth as per original item.

Replacement cylinder kit for Minarelli-based, air-cooled Chinese-built engines (Euro2 till 2003) e.g.: CPI, Keeway etc. Great price! The cylinder k...

These Speed-up shims influence the length of the variator sleeve. Lengthening can improve acceleration and shortening can increase top end speed. M...

Variable tuning set for original variators and almost all tuning variators. The Speed-up shims can influence the length of the sleeve: an extension...

The rectifier/controller converts the alternating voltage from the alternator into the DC for the on board computer. This keeps the battery charged...

Complete alternator for Minarelli-based 2-stroke engines. Suitable for Keeway, CPI, Generic, Longjia, Mawi etc. There are currently 4 different ver...

Bolt and nut set for Chinese-built 2-stroke scooters, Keeway etc. with almost all bolts, oil draining plugs, nuts, cylinder studs etc. Ordering ind...

15mm gudgeon pin circlips from Naraku. Ensure the clip groove is clean and will allow the circlip to seat properly. When installing, we recommend o...

Variator back plate for GY6 125/150cc 4-stroke Chinese-built engines. This component corresponds to 100% of the original. Only for 15 mm tail shaft!

Complete left-hand fork leg for 125/150cc GY6 Chinese-built scooters. Ready to install. Stanchion tube diameter: 30mm, Length: 485mm Please careful...

Complete left-hand fork leg [brake calliper side] for 125/150cc GY6 Chinese-built scooters. Ready to install. Stanchion tube diameter: 30mm, Length...

Complete replacement indicators for CPI, Keeway, Kymco and Rieju scooters and geared motorcycles. The turn signal corresponds to the original part....

Complete replacement indicators CPI, Keeway, Kymco and Rieju scooters and geared motorcycles. The turn signal corresponds to the original part. Rep...

Replacement LED taillight in with white glass for various CPI, Derbi, MH and Rieju scooters or geared mopeds. Matches the dimensions of the origina...

Vacuum-operated fuel tap for various Kymco and SYM scooters. Securing nut thread: M16x1.5mm Only for scooters with metal fuel tanks!!! OEM-quality.

Exhaust heat guard. Often becomes damaged in a spill and changing it will refresh the look of your machine. Delivery is for 1 head guard in black.

Counterpressure spring mounting tool for convertor units 125-155mm outer diameter.

Malossi Racing clutch spring set. Springs suitable for various Maxi scooters with original 3 shoe clutches from 125-200cc. Set comprises 3 differen...

Wheel-mounted speedo drive for speedo cables with two spokes, retainer nut and square drive. The speedo cable is suitable for Chinese-built 4-strok...

Fan Wheel for air cooling. This item sits on the alternator rotor and is attached with 4 screws.

These cylinder gasket sets contain all the necessary gaskets from the cylinder base upwards. They can be optionally used on 70cc Naraku 2-stroke cy...

Cost-effective replacement belt for everyday use. Good flex and outstanding grip and can easily be used in lightly tuned engines. Size: 835x20x30

Cost-effective replacement belt for everyday use. Good flex and outstanding grip and can easily be used in lightly tuned engines. Size: 743-18-20

Piston ring set for 70cc Naraku cylinder kit for 1E40QMB engines with 12mm gudgeon pin.

Malossi draw on 20 years of tuning transmissions. A longer ratio allows for higher top end speed on Minarelli engines. Longer ratios are only reall...

Very high quality Malossi crank for 12mm gudgeon pins. Typical Malossi high quality. Full cheek design for higher pre-compression, for max fill and...

Malossi 50cc sports cylinder for all CPI/ Keeway and Generic models (from 2003 on). Malossi sport 50 cast iron cylinder with altered timing and lar...

High-quality replacement piston for 50cc original and 50cc Naraku cylinders for Minarelli 1E40QMB engines. Delivery as shown, including: piston rin...

High Tech convertor plate in extremely resistant nitride steel from Malossi. Features straight guide grooves for better acceleration. 2x different ...

Counter pressure spring by Polini [Evo-Slider] with a diameter of 45mm for Minarelli/CPI/Morini scooters. The kit includes a eve slider plastic pla...

Quick and simple replacement lever for broken or damaged clutch or brake levers. Matches original shape, colour and mount. Single lever supplied. 4...

Brake pads with organic composition. This coating mixture is generally used by the original scooter manufacturers as the OEM part. Solid brake perf...

This piston ring set can be optionally used in Naraku 2-stroke cylinders, but is also suitable for original cylinders and standard cast iron cylind...

These Naraku cylinder gasket sets contain all the necessary gaskets from the base gasket upwards and can be optionally used on the Naraku 2-stroke ...

The Naraku Traffic system combines contemporary fresh lines with a pleasant engine note. This system integrates very well with new modern vehicles....

Dowel pin set for 125/150cc GY6 engines. Delivery contains: 6x dowel pins for M8 and 8x dowel pins for M6.

Naraku clutch spring set for 125/150cc original and Naraku sports clutches for GY6, Kymco, Honda, Malaguti, Keeway Maxi scooters.+1500 rpm +2000rpm...

Current Naraku counterpressure springs with different alloying of the spring steel. A necessary addition where engines have been tuned. RPM increas...

Naraku High Performance clutch bell with patented R-Vent system for more fresh air over the clutch. Prevents wear and loss of friction. Great value...

Replacement fuel tank cap in original design for Keeway F-ACT 50/ 125/ 150, Focus 50/ 125/ 150. Can replace tank cover with OEM-No. 88400BMBT000 / ...

Replacement right-hand mirror in original design with E-certification for Keeway Focus 50/ 125/ 150, Hurricane 50, ATV 50, ARN 125/ 150, F-Act 125,...

Replacement right-hand mirror in original design with E-certification for Benelli, Generic, Vespa and Keeway Scooters. Cheaper alternative to expen...

Replacement right-hand mirror in original design with E-certification for various Benelli, Generic, Vespa and Keeway scooters. Cheaper alternative ...