Vento

3 Set of sliders for the Naraku Maxi Speed variator for scooters with 125cc GY6 and Kymco AC engines.

Aluminum Kickstarter [Light] suitable for Minarelli and Peugeot engines. White

Alternator rotor puller for Aprilia models with Aprilia engines, Suzuki, geared mopeds and horizontal cylinder Minarelli engines. alternative to st...

Telescopic fork for CPI, Oliver, Hussar and Popcorn as well as Keeway Focus, Fact and more. Also suitable for many Chinese-built 2-stroke scooters....

Locking spring for kick-starter carrier sprockets.

Kickstart gear for upright and horizontal Minarelli and Minarelli-based 2-stroke engines as found in CPI, Keeway, Mawi, Longija etc.

Recoil spring for kickstarter levers on CPI, Keeway, Generic and Minarelli-based Chinese-built 2-stroke engines.

Replacement reed valve gasket for horizontal 50cc 2-stroke Minarelli engines and Aprilia/Suzuki engines. Please check that a gasket is required on ...

Universal handlebar grip for scooters, motorcycles and quads/ATVs with 22mm diameter handlebars. outer length: 120mm inner length: 115mm

Rotor/magnet wheel for alternators. Alternators are currently available with 6 or 8 coils. Please check your original item to check which one you r...

Complete engine gasket set for 125/150cc GY6 engines (152QMI). Contains all relevant gaskets. Cheaper than individual purchasing. Does not include ...

This intermediate transmission shaft is supplied pre-pressed. Same number of teeth as the original 13/52 teeth.

Gearbox input shaft. This is where the clutch is mounted. 13 teeth as per original item.

Replacement cylinder kit for Minarelli-based, air-cooled Chinese-built engines (Euro2 till 2003) e.g.: CPI, Keeway etc. Great price! The cylinder k...

These Speed-up shims influence the length of the variator sleeve. Lengthening can improve acceleration and shortening can increase top end speed. M...

Variable tuning set for original variators and almost all tuning variators. The Speed-up shims can influence the length of the sleeve: an extension...

The rectifier/controller converts the alternating voltage from the alternator into the DC for the on board computer. This keeps the battery charged...

Complete alternator for Minarelli-based 2-stroke engines. Suitable for Keeway, CPI, Generic, Longjia, Mawi etc. There are currently 4 different ver...

Bolt and nut set for Chinese-built 2-stroke scooters, Keeway etc. with almost all bolts, oil draining plugs, nuts, cylinder studs etc. Ordering ind...

15mm gudgeon pin circlips from Naraku. Ensure the clip groove is clean and will allow the circlip to seat properly. When installing, we recommend o...

Variator back plate for GY6 125/150cc 4-stroke Chinese-built engines. This component corresponds to 100% of the original. Only for 15 mm tail shaft!

Complete left-hand fork leg for 125/150cc GY6 Chinese-built scooters. Ready to install. Stanchion tube diameter: 30mm, Length: 485mm Please careful...

Complete left-hand fork leg [brake calliper side] for 125/150cc GY6 Chinese-built scooters. Ready to install. Stanchion tube diameter: 30mm, Length...

Complete left-hand fork leg [brake calliper side] for 125/150cc GY6 Chinese-built scooters. Ready to install. Stanchion tube diameter: 30mm, Length...