Yamaha

Complete set of head race bearings (top and bottom) as shown in image. Bearings should always be replaced when fitting a new yoke/stem or if your s...

Malossi MHR carburettor kit for solid power curve right up to the top end. Dellorto 19mm PHBG is a solid starting point for mid to high end cylinde...

Kickstarter shaft [72mm / 24mm] - GY6 50cc

Innovative intake manifold in extreme heat and fuel-resistant Viton from the Malossi Racing MHR series. Intake manifold features 30mm opening, maki...

Malossi 4 reed racing reed block. 0.3mm thick reeds give great power when used with the Malossi Big Valve blocks. Malossi offers 2 additional membr...

Malossi MHR intake manifold with short opening and straight connection. 22/24.5mm variant has a 22mm opening and a 24.5mm carb carb connection 19-2...

Reeds for original factory reed block with carbon membranes. These cause less damaged to the engine should the reed petals break up than metal alte...

Polini Air Speed variator pulley, great upgrade for the original due to design producing increase cooling. Suitable for 16mm shafts only.

Many vehicles are factory-fitted with restrictors or restricted CDI units. Malossi offer this clever RPM Control Racing CDI unit. 35,000 - 50,000V ...

Many vehicles are factory-fitted with restrictors or restricted CDI units. Malossi offer this clever RPM Control Racing CDI unit. 35,000 - 50,000V ...

Set of 3 sliders for Malossi Multivar variators. Sliders should be replaced to avoid damage. Not suitable for Piaggio MHR variators.

M10x1.25mm nut for front belt pulleys. For Minarelli engines or other models with the same dimensions. (Thread on the variator side of the crank).

Little end bearing for 12mm gudgeon pin. This size is generally found on CPI, Keeway, Mawi, Longija, Generic engines etc. from 2003 on, as well as ...

Standard brake shoes. Also included: 2 new springs. Performance and construction as per original item. Dimensions: 110mmx25mm For rear drum brakes ...

IRC Urban Snow Winter tyre allows you to be on the move even in the coldest conditions to the Autumn/Winter has to throw at you. Great performance ...

Aluminum Kickstarter [Light] in carbon look suitable for Minarelli and Peugeot engines.

Aluminum Kickstarter [Light] suitable for Minarelli and Peugeot engines.

The Naraku HS-Racing is a well-engineered High Speed variator for Minarelli-based 2-stroke engines with a 16mm tail shaft. The variator comes with ...

The starter clutch carrier wheel transfers the power from the starter to the clutch. If the teeth on the e-starter or the clutch are damaged, they ...

Kickstarter shaft [63mm / 31mm] - GY6 50cc

Low-cost front brake disc, Asian-designed. For everyday use on untuned vehicles. Worn brake pads cause extreme wear to brake discs. Braking perform...

Polini Hi-Speed offers some of the strongest drive of any variator on the market. The roller surfaces make for improve transfer of power meaning in...