Yamaha

Gasket for vehicles not fitted with a round exhaust manifold gasket. This is a universal gasket for all flat exhaust manifolds. Solid design and a ...

Vacuum-operated fuel tap for various scooters with Piaggio engines. Fitment diameter in tank: 15mm

Gasket for vehicles not fitted with a round exhaust manifold gasket. This is a universal gasket for all flat exhaust manifolds. Solid design and a ...

39mm clutch nut M28x1 (central nut under the clutch bell). Suitable for Minarelli, Kymco, Peugeot, Honda engines and many more.

Kickstarter wheel [carrier] for upright and horizontal Minarelli and Minarelli-based 2-stroke engines as found in CPI, Keeway, Mawi, Longija etc.

101 Octane intake manifold for Minarelli Engines with vertical cylinder. As a result of thermal loading, tears can occur in the intake manifold and...

Brake shoe set with ribbed surface. The ribbed section prevents the over-accumulation of brake dust deposits, which generally lead to glazing and a...

rear pulley converter kit incl. clutch / clutch torque converter assembly

Very low-cost intake manifold for derestricting the inlet port. This increases the size of the opening to 21mm. This is a must when using a larger ...

Float bowl gasket for Keihin PWK carburettor.

Replacement speedometer drive gear for Yamaha Aerox, BWs as well as MBK Nitro, Booster scooters with 10mm wheel axles.

Aftermarket part for defective kick-start shafts. Item matches design and size of the original.

Shaft oil seal Internal diameter: 20mm, External diameter: 42mm, Thickness/Depth: 8/9mm

Replacement oil pump drive gear for scooters with Minarelli-based 2-stroke Chinese-built engines and Minarelli 50cc 2-stroke AC/LC engines.

Replacement clutch bell for lightly-tuned engines. Matches the dimensions of the original (107mm). Cheapest clutch we offer, but definitely worth t...

Kick-starter, straight design with solid kicker head. Approx. 14cm. Please measure, as there may be clearance issues with the variator cover. Suppl...

Complete starter clutch. The counter piece of the electrical starter is responsible for uncoupling the starter once the engine is running. If this ...

Low-cost, standard brake shoes. Supplied with a set of new shoe springs. Size: 110x25mm Generally for rear brake use, but can be used for front on ...

Catching or sticking points in the steering are serious safety hazards. The only option is changing the complete steering bearing set up. You recei...

Rectifier / Controller changes the AC into DC on a 12V board. This prevents bulbs from burning out. Exposure to high temperatures means bulbs often...

M10x1 nut for clutch bells for all Minarelli and Minarelli-based engines.

Little end bearings for Minarelli/Morini engines with 10mm gudgeon pins.

Accompanying kickstarter part. Should also be replaced when changing the cog.

The Vicma Evo Racing and Hebo clutches are identical settings in principal. The Hebo differs mainly in the clutch linings. 3 Shoe clutch with varia...