Yamaha

Gasket for vehicles not fitted with a round exhaust manifold gasket. This is a universal gasket for all flat exhaust manifolds. Solid design and a ...

Very low-cost intake manifold for derestricting the inlet port. This increases the size of the opening to 21mm. This is a must when using a larger ...

Vacuum-operated fuel tap for various scooters with Piaggio engines. Fitment diameter in tank: 15mm

This aftermarket air box is identical in design and construction to the original. Low-cost replacement for defect items or for returning to origina...

Gasket for vehicles not fitted with a round exhaust manifold gasket. This is a universal gasket for all flat exhaust manifolds. Solid design and a ...

Aftermarket carburettor for all 2-stroke scooters with 1E40QMB engines. Minarelli replica air-cooled. Comes with electric choke. Note: In rare case...

39mm clutch nut M28x1 (central nut under the clutch bell). Suitable for Minarelli, Kymco, Peugeot, Honda engines and many more.

Kickstarter wheel [carrier] for upright and horizontal Minarelli and Minarelli-based 2-stroke engines as found in CPI, Keeway, Mawi, Longija etc.

Replacement reed block with steel petals. Suitable for all horizontal Minarelli engines, CPI, Keeway, Generic, Mawi, Longija, Morini engines, April...

rear pulley converter kit incl. clutch / clutch torque converter assembly

Low-cost import exhaust system for scooters with horizontal Minarelli engines. Originally for 10” wheel scooters, but with a few minor modificati...

Very good quality aftermarket crank for horizontal 50cc Minarelli AC and LC engines. The crank is a 100% match to the original and is an outstandin...

Float bowl gasket for Keihin PWK carburettor.

Aftermarket part for defective kick-start shafts. Item matches design and size of the original.

Folding black kickstarter. Low-cost replacement for Minarelli engines with horizontal cylinderss and Chinese-built 2-stroke Minarelli-based engines...

Shaft oil seal Internal diameter: 20mm, External diameter: 42mm, Thickness/Depth: 8/9mm

Replacement oil pump drive gear for scooters with Minarelli-based 2-stroke Chinese-built engines and Minarelli 50cc 2-stroke AC/LC engines.

Replacement clutch bell for lightly-tuned engines. Matches the dimensions of the original (107mm). Cheapest clutch we offer, but definitely worth t...

Transparent coolant hose with 15mm internal diameter, 1m in length. 15mm coolant hoses are often used on scooters and mopeds with Minarelli engines...

Kick-starter, straight design with solid kicker head. Approx. 14cm. Please measure, as there may be clearance issues with the variator cover. Suppl...

Complete engine gasket set for horizontal Minarelli AC and LC engines. This gasket set contains all the relevant engine gaskets for air- and water-...

Complete starter clutch. The counter piece of the electrical starter is responsible for uncoupling the starter once the engine is running. If this ...

Rectifier / Controller changes the AC into DC on a 12V board. This prevents bulbs from burning out. Exposure to high temperatures means bulbs often...

M10x1 nut for clutch bells for all Minarelli and Minarelli-based engines.

Little end bearings for Minarelli/Morini engines with 10mm gudgeon pins.

Accompanying kickstarter part. Should also be replaced when changing the cog.

Having a large intake manifold makes little difference without the correct reed block. This low-cost racing reed block makes for a clear path and g...

The Vicma Evo Racing and Hebo clutches are identical settings in principal. The Hebo differs mainly in the clutch linings. 3 Shoe clutch with varia...