Motoworx

Naraku V.3 carburettor 18.5mm for 50cc 4-stroke scooters. Top quality at an affordable price. No start issues as with Chinese alternatives and good...

Naraku small end bearing [HD-Quality] - 10x14x13. Suitable for Minarelli and Morini engines with 10mm gudgeon pin.

This regulator is similar to the NARAKU ignition coil. The controller reaches a significantly higher output than the standard controller by ensurin...

Aluminium height adjuster set for rear shocks, from Naraku Performance. This height adjuster set gives scooters a more dynamic look by raising the ...

Aluminium height adjuster set for rear shocks, from Naraku Performance. This height adjuster set gives scooters a more dynamic look by raising the ...

Naraku Sports Contra Spring V.2 +1000 rpm The current version of the Naraku counter pressure spring uses a modified alloy spring providing better r...

Naraku sport clutch spring set for all Minarelli original and Naraku sports clutches. 3 different graded spring rates supplied, with the rpm value ...

These Speed-up shims influence the length of the variator sleeve. Lengthening can improve acceleration and shortening can increase top end speed. M...

Repair kit for 24mm Naraku carburettors. Comes with adjustable needle, needle clip, main jet, pilot jet, float bowl gasket, idle jet, mix adjuster ...

NARAKU V.2 intake manifold for 50cc GY6 and all GY6-based models, as well as Honda Monkey and Monkey replica engines. Unlike the original part, whi...

Aluminium height adjuster set for rear shocks, from Naraku Performance. This height adjuster set gives scooters a more dynamic look by raising the ...

Cylinder studs including special nuts with M7 thread for securing the cylinder. Set of 4 with nuts. Length: 110mm, nuts are 13mm in length and have...

Naraku replacement variator for 50cc horizontal and upright 2-stroke Minarelli engines with 13mm tail shaft. The weight tracks correspond to the or...

Twist Control: an absolute drive innovation from Naraku. Twist Control absorbs the torsion from the converter and even out the loss of power from t...

Twist Control: an absolute drive innovation from Naraku. Twist Control absorbs the torsion from the converter and even out the loss of power from t...

Naraku HD (Heavy Duty) crank main bearing set. Set contains left and right in metal cage crank bearings and relevant shaft seals. Only bearings wit...

This Variator sleeve replaces the original factory fitted sleeve and collar. This lifts the restricted power. The scooter will be capable of approx...

Exhaust manifold gasket for scooters and mopeds with original and tuning/sports exhaust systems with round metal gaskets and dimensions of approx. ...

The NARAKU crossover combines Racing design with an internal structure that is tailored to the requirements of 4-stroke engines. Road legal thanks ...

Set of 3 Naraku clutch springs for original clutches. 3 different strengths. Engagement point RPM alters in accordance with the value on the spring...

Exhaust manifold gasket for all Chinese-built 4-stroke and Kymco 50cc 4-stroke vehicles. Also suitable for all Naraku 4-stroke tuning cylinder kits...

10mm gudgeon pin circlips from Naraku. Ensure the clip groove is clean and will allow the circlip to seat properly. When installing, we recommend o...